2. Setting up and pairing your sensor hub to the WiFi adaptor

NOTE: Complete this step at your home office, near the FarmSense WiFi Adapter. WiFi adaptor must already be configured and connected to your Home/Office WiFi Internet.

2.1 Install the antenna to the Sensor Hub, it should be finger tight.

2.2 Connect the sensor to the Sensor Hub, the push-lock connector will “click” when it is correctly installed. The Sensor Hub will beep twice.

2.3 On the WiFi Adapter, wait until the Network LED is not flashing, then press and hold the Network button until you hear a single beep, the Network LED will begin to flash rapidly.

2.4 On the Sensor Hub, press and hold the Network button until you hear a single beep. The Network LED will begin to flash rapidly.

2.5 When the units have paired, both units will beep twice and the network LED on the Sensor Hub will be on.

2.6 The Sensor Hub is now ready to install. Complete these steps for each Sensor Hub that you wish to install.

2.7 It is recommended to disconnect the sensor and antenna prior to transporting to your installation location to prevent any damage. To disconnect the sensor fromSensor Hub rotate the blue collar and pull – do not pull on the sensor cable.

Powered by BetterDocs